Panasonic WH-ADC0916G9E8 WH-UX09FE8 Service Manual page 26

4.1.2 To adjust initial settings
Dealer
Select menus and determine settings according to the system available in the
household. It is recommended that all alterations of settings are done by an
authorised dealer or specialist.
• After initial installation, you may manually adjust the settings.
The initial setting remains active until the user changes it.
• Ensure the operation LED is OFF before setting.
• The system may not work properly if set wrongly. Please consult
an authorised dealer.
1 P e r s s and
5 seconds until the display shows SETTING STATUS.
2 P e r s s or
3 Press
to enter the menu.
4 P e r s s or
YES: to enable the menu
No: to disable the menu
5 P e r s s to confirm.
Before Indoor Unit operate, its Capacity
Rank has to match with connected
Outdoor Unit. See below table for detail.
Model
Indoor Unit
WH-ADC0916G9E8
Menu (1 ~ 15)
1
Room Thermostat Connection
To select whether or not to connect to the optional room thermostat.
2 Indoor Backup Heater Selection
To reduce the heater power if unnecessary.
*Options of kW vary depending on the model.
3 Water System Freeze Prevention
To activate or deactivate the water freeze prevention when the
system is OFF.
4
* * Cooling/Heating Operation Interval
1, 2
To set the interval for COOL or HEAT mode during COOL + TANK or
HEAT + TANK mode.
5 * Tank Heat-up Interval
1
To set the interval for the water tank during COOL + TANK or HEAT
+ TANK mode.
simultaneously and hold for
to select the menu.
to select Yes/No, or other options.
Capacity Rank
Outdoor Unit
WH-UX09FE8
WH-UX12FE8 12
WH-UX16FE8 16
WH-UD09FE8
WH-UD12FE8 12
WH-UD16FE8 16
Operation LED
System Capacity Rank Setting
The Capacity Rank can be set by Control Panel
1 P e r s s
seconds.
2 P e r s s
9
3 Press
to change capacity rank and press
confirm the outdoor capacity rank.
9
4 Press
Default
Setting
NO
9 kW
YES
30 minutes
1 hour
35 minutes
26
Display
Control Panel
and buttons simultaneously for 5
or button to select menu CAP RAN.
button then press or
button and Exit to home display.
Setting Display
YES NO
*3 kW / 6 kW /
9 kW
YES NO
0.5 hours ~
10 hours
5 minutes ~
1 hour 35 minutes
button
button to