Setting An Administrative Password - Epson SureColor S40600 Assembly

Configuring the printer for your network
Once the printer is connected to your network, follow these steps to configure it:
Turn on the printer.
1.
Start EpsonNet Config.
2.
The EpsonNet Config program you installed from the USB flash drive that came with your printer
searches for all Epson printers on the network and displays the MAC address for each printer that it
finds.
Highlight the printer you want to configure and click
3.
screen.
If necessary, contact your network administrator for instructions on assigning an appropriate IP
4.
address. A static IP address is recommended.

Setting an administrative password

If your computer is connected to the printer over a network connection, it is recommended that you set an
administrative password after installing the product's software.
Note: Be sure to write down or note the password. If you forget or lose the password, see the online User's
Guide for help.
Open a web browser from a computer connected to the printer.
1.
Enter your product's IP address into the address bar.
2.
Click from the navigation menu.
Password
3.
Enter a password and then close the web browser.
4.
Updating your printer firmware
If you installed the Epson Control Dashboard, launch the application and view the help section for
instructions on updating the printer firmware. This will help to ensure that your printer features and
functionality is up to date.
Configuring the printer for your network
Configuration
to access the TCP/IP selection
|
29