Numark cdmix usb User Manual page 8

Navigating MP3 Folders
One way to organize MP3 files is by putting them into separate folders. Folders make it easier to quickly find the music you
want.
1. Connect a USB thumb drive to one of the USB ports on CDMix USB.
2. When the USB thumb drive is ready, the LCD display will change from "SCAN" to displaying the folder name.
3. Press the FOLDER button.
4. Use the TRACK SELECT knob to scan through the named folders contained on the drive. Press the TRACK SELECT
knob to open a folder.
5. Use the TRACK SELECT knob to scan through the tracks contained within the folder.
6. Press the TRACK SELECT knob to play a track.
Looping
The CDMix USB has a seamless looping feature, which means that if you define a loop, there is no delay when the music
loops back to the beginning. This looping feature allows you to be very creative with your mixes, allowing you to extend
desired sections of a song for as long as you want, or create remixes on the fly!
There are three buttons used for looping:
LOOP IN: This is the point where you would like a loop to start. By default, a "loop in" point is automatically set at the
beginning of the song. To define a new "loop in" point, press the LOOP IN button when the song reaches the desired point
where you would like a loop to begin. The LOOP IN button will light, indicating a new "loop in" point has been set. The
RELOOP/STUTTER button will also illuminate indicating that you can now press it to immediately go back to the "loop in"
point and begin playing. If you wish to change the "loop in" point, just press the LOOP IN button again.
LOOP OUT: Sets the end point of the loop. The first time you press LOOP OUT while a song is playing, the LOOP OUT button
will blink, and the song will begin playing in a seamless loop, starting from the "loop in" point and ending at the "loop out"
point. To release, or end the loop, press LOOP OUT a second time and play will continue forward when the song passes the
previously set loop out point. The LOOP OUT button will then be continuously lit, indicating that the loop is now in memory for
re-looping purposes.
RELOOP / STUTTER: Repeats play or "stutters" (if repeatedly tapped) from the loop in point. If a loop has previously been
set, it plays and repeats that loop, until the loop is released by pressing the LOOP OUT button.
Press LOOP IN to set the beginning of the loop, then
press LOOP OUT to set the end point of the loop. Once
you press LOOP out, the CDMix USB will loop between
these two points. If you press LOOP OUT again, the
CDMix USB will exit the loop and continue playing
normally.
The "loop in" point can also be used as a
way to "stutter" play beginning from a
certain point in a song. Just press LOOP IN
to set the "stutter point", then press
RELOOP to begin play from the stutter
point. Each time you press RELOOP the
CDMix USB will jump back to the stutter
point and play from that point.
8
If you press LOOP IN but then
decide you want to
different "loop in" point, just
press LOOP IN again. Then
press LOOP OUT to
looping between the IN and OUT
points.
set a
start