Cushman Turf Truckster Safety And Operation Manual page 15

N. Gear Selector
The gear selector is used to shift transmission into
desired gear. Refer to ground speed decal to
determine required gear.
Manual Transmission: Gear selector knob has the
"H" shift pattern design molded into the top surface.
1 3
"H" Shift
2 4 R
Automatic Transmission: Gear selector has six
positions, Park (P), Reverse (R), Neutral (N), Drive
(D), Second (2) and Low (L). Engine will not start
unless selector is in Park (P) or Neutral (N).
Push in selector button when shifting from Park (P),
shifting into Neutral (N) or when shifting from Drive
(D) to Second (2) or Low (L).
Selector Button
P. Accessory Power Plug
Allows operation of approved 12 Volt accessories
and attachments. To prevent excessive battery drain,
only use 12 volt outlet with engine running.
!
CAUTION
The 12 Volt Accessory outlet circuit is protected by a
15 Amp fuse. Do not attempt to use attachment(s)
with a combined power rating greater than 180 Watts.
To prevent the risk or burns or fire do not replace 15
amp fuse with a higher amperage rating fuse.
Pattern
Figure 4C
P
R
N
D
2
L
Figure 4D
R
T
R. Hand Throttle
Used to set engine speed for remote operations.
Increasing hand
accelerator pedal.
Never attempt to drive the vehicle with the engine speed
controlled by hand throttle.
S. Governor Control
Used to lower pre-set governor rpm limits for hand
and foot throttle operation.
Push lever all the way up to use pre-set rpm limit.
Pull lever down as required to lower maximum rpm.
T. Light Switch
The light switch is used to turn the headlights and
taillight on. The switch has three positions, OFF,
LOW BEAM, and HIGH BEAM. Push switch up one
detent for LOW BEAM or push switch up two detents
for HIGH BEAM.
U. Horn Button
The horn button is located to the left of the steering
wheel, below the dash panel. Depress to sound horn.
Horn will not sound when the ignition switch is in the
OFF position.
CONTROLS
S
U
844116
Figure 4E
throttle speed will
4
depress
en-15