Cushman Turf Truckster Safety And Operation Manual page 16

4 CONTROLS
V. Clutch Pedal - Manual Transmission only: Used
to disengage the power output from engine to
transmission. This allows shifting of transmission
gears. Do not attempt to shift gears without fully
depressing clutch pedal.
The clutch pedal is equipped with an interlock switch.
This switch prevents the starter from operating
unless the clutch is disengaged (the clutch pedal is
depressed). See 5.2.
W. Service Brake Pedal - Depress the pedal to slow or
stop the vehicle.
If the brakes DO NOT stop the vehicle properly, the
brakes must be adjusted or repaired.
X. Accelerator Pedal - Push pedal down to open
throttle (increase speed), release to return throttle to
idle position (decrease speed).
Y. Differential Shift Cable
Used to shift differential from LOW to
HIGH speed range. Do not shift
differential while vehicle is moving.
Push handle all the way down to shift
differential into LOW speed range.
Pull handle up all the way to shift
differential into HIGH speed range.
Placing handle in middle detent position places the
differential in Neutral. Parking brake must be
engaged or service pedal depressed with differential
in Neutral to prevent the vehicle moving.
en-16
P
X
W
V
Figure 4F
AB
AA
Z. Parking Brake Lever
The park brake lever is located to the left side of the
drivers seat. Whenever using the parking brake, shift
transmission to 1st Gear (Manual Transmission) or
Park (Automatic Transmission), and shut off engine.
To engage the brake, pull up on the lever until park
brake is applied.
To release; while slightly pulling up on the handle,
push the button at the end of the lever and while
holding the button in, lower the lever to it's original
position.
AA.Remote Hydraulics Control
Used to engage and disengage remote
hydraulic system.
R
Push knob down to use lift control
system
hydraulics.
Pull knob
hydraulics and disable lift control system.
AB.Lift Control System
Used to control hydraulic bed lift. Push
Remote hydraulics control knob (AA) to
activate hydraulic lift system.
Pull back on the lever to extend the cylinder
(Raise the dump box).
N
Push forward on the lever to retract the
cylinder (Lower the dump box).
Push forward and to the right to place lever in
float position.
Y
Z
Figure 4G
and disengage
up to activate
remote
remote