Changing The Volume And Sound; Switching The Broadcast Audio Channel - Pioneer PDP-SX5080D Operating Instructions Manual

Watching TV

Changing the volume and sound

Use the remote control or the control panel on the right-hand side
of the plasma television to adjust the volume.
Using i + / i – on the remote control unit
• Press i + to increase the volume.
• Press i – to decrease the volume.
Volume adjustment
• VOLUME +/– on the plasma television operates the same as
i + / i –.
Using e on the remote control unit
Press e to mute the sound.
1
e appears on the screen.
Muting
Press e again or i + to restore the sound.
2

Switching the broadcast audio channel

Depending on the broadcast, you can switch the audio channel.
Press - to change the audio channel.
•
mode
I II
mode MONO mode
MONO
The table below shows the available audio channels by broadcast
audio type.
1
AAA
Stereo
NICAM STEREO
10:00
2
BBB
Bilingual
NICAM I
10:00
3
CCC
Monaural
NICAM MONO
10:00
4
DDD
Stereo
STEREO
10:00
5
EEE
Bilingual
DUAL I
10:00
6
FFF
Monaural
MONO
10:00
7
GGG
STEREO
10:00
Note
• In each of the sound multiplex mode selected using the -
button, the display changes depending on broadcasting signals
being received.
• Once the MONO mode is selected, the sound remains mono
even if the system receives a stereo broadcast. You must switch
the mode back to  or  mode if you want to hear stereo sound
again.
• Selecting a sound multiplex mode while the input source is
"INPUT 1" to "INPUT 5" does not change the type of sound. In
this case, sound is determined by the video source.
Setting
MONO
1 1
AAA AAA
NICAM STEREO MONO
10:00 10:00
2 2
BBB BBB
NICAM II MONO
10:00 10:00
3 3
CCC CCC
NICAM MONO MONO
10:00 10:00
4 4
DDD DDD
STEREO MONO
10:00 10:00
5 5
EEE EEE
DUAL II MONO
10:00 10:00
6 6
FFF FFF
MONO MONO
10:00 10:00
7 7
GGG GGG
STEREO MONO
10:00 10:00
06
23
En