Hardware Setup - D-Link DNS-325 Quick Installation Manual

this section provides installation information for the sharecenter shadow. to
install the sharecenter shadow on your local network, refer to the steps below:
y Lock
1. to remove the front panel, firmly
Note: make sure to align the drive connector to the sata connector on the
bottom edge inside the drive bay of the sharecenter shadow. Gently push the
drive in until it connects. When a drive is inserted properly, you will feel it "seat"
into the connector. some hard drives that are thin or oddly shaped may need to
be guided carefully into position. If a drive is not properly seated, the light will
not illuminate after powering on the device.
dnS-325
grip the panel and slide it up until
the 6 panel hooks clear the slot
openings.

Hardware Setup

Slide
Up
2. Insert a 3.5" sata hard drive into
an available drive bay.
5