Table of Contents
Advertisement
Section 2 - Installation
Follow the instructions below to install a hard drive, connect to the network and power on the ShareCenter. Open the
shipping carton for the ShareCenter and carefully remove and unwrap its contents. Follow the instructions below to
setup the ShareCenter. If this is the irst time using the ShareCenter or if a new hard disk is installed, use the Easy
Search utility located on the Installation CD and follow the instructions for setting up, coniguring and formatting the
new drive.
To install ShareCenter on your local network, refer to the steps below:
1.. Put.a.3.5".SATA.hard.drive.into.a.drive.tray.and.use.
screws.to.fasten.the.hard.drive.with.the.tray..There.
are.four.holes.for.fastening.the.screws..Two.holes.
are.circled. in.red.in.the.image,.and.the.other.two.
holes.are.on.the.other.side.of.the.drive.tray.
2.. Open.the.faceplate.to.access.the.drive.bays.
D-Link ShareCenter Pro 1200 User Manual
Installation
Hardware Setup
7
Advertisement
Table of Contents
