Wiring Connection - Kenwood KDC-BT39DAB Instruction Manual

INSTALLATION / CONNECTION

Wiring connection

Antenna terminal
DAB antenna jack ( 25)
Connecting the ISO connectors on some VW/Audi or
Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied
wiring harness as illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function
A4 Yellow : Battery
A5 Blue/White : Power control
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
B1 Purple ]
: Rear speaker (right)
Purple/black [
B2
Gray ]
B3
: Front speaker (right)
Gray/black [
B4
B5 White ]
: Front speaker (left)
White/black [
B6
Green ]
B7
: Rear speaker (left)
Green/black [
B8
24
Rear/subwoofer output
Yellow
(Battery wire)
Red
Ignition wire
(Ignition wire)
(Red)
Unit
Battery wire
(Yellow)
Red (A7)
Yellow (A4)
(For
MIC (microphone input terminal)
( 11)
Fuse (10 A)
If no connections are made, do not let the
wire come out from the tab.
STEERING WHEEL
Light blue/yellow
REMOTE INPUT
To the steering wheel remote
(Steering remote control adapter
REMOTE CONT
control wire)
To the power control terminal
when using the optional
Blue/White ANT CONT
power amplifier or to the
(Power control
P. CONT
antenna control terminal in
wire/ Antenna
the vehicle
control wire)
(For
To connect the Kenwood
navigation system, refer your
navigations manual
Brown
(For
To the terminal that
(Mute control
MUTE
is grounded when the
wire)
telephone rings or during
conversation ( 19)
(To connect the Kenwood
ISO connectors
navigation system, refer your
navigations manual.)
When connecting to an
)
external amplifier, connect its
ground wire to the car's chassis
to avoid damaging the unit.
Part list for
installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
)
(D) Wiring harness
)
(E) Extraction key