Table of Contents
Advertisement
Notes on the user guide
Input of Chinese characters
Names can be entered in the directory in
Chinese characters, with a maximum
length of 8 characters. The Pinyin input
mode is used.
Please proceed as follows:
¤
Open the directory, choose an entry or
make a new one and navigate to the
"Name" field.
¤
Change the mode to "Chinese".
¤
Press the required Pinyin letter (keys 2
to 9). The following popup window
appears:
New Entry
+48601413688
Û
¤
Enter a further Pinyin letter. If you have
entered a wrong letter, you can delete
X
with
.
As soon as the character corresponding
to the Pinyin input is found, it is shown
in the selection line.
New Entry
+48601413688
Û
26
Pinyin
edit line
¤
selection line
OK
¤
Choose the required character with the
left/right control key r and enter it
into the name field with
Alternatively you can press the key (1-
6) which is shown above the required
character.
Note:
u
In order to get as close to the
required character as possible,
enter Pinyin tones from 1 bis 5 . To
do so, press the hash key #. The
corresponding digit is shown at the
end of the edit line. Each time the
hash key is pressed the value
increases by 1.
u
To be able to enter symbols and
special characters, press the
Q key. You can then select and
enter the required symbol in the
selection line as described above.
[
.
Advertisement
Table of Contents
