Bissell POWERWASH DELUXE Manual page 10

D4 – Pump belt removal &
replacement
Occasional replacement of the pump belt
may become necessary. If needed, please
follow instructions below.
1. Turn off machine and unplug it from outlet.
Wrap hose and cord on racks.
2. Remove 2-in-1 water tank and set aside.
3. IMPORTANT: Fully recline handle and turn
unit upside down.
4. Locate red belt access door and remove
two screws.
NOTE: The dark screw is a long machine
screw and will take approximately 25 full
turns to completely remove. The head of
the screw will lift from the belt access door
so that it can be easily removed.
5. Remove belt access door assembly from
end of brush and set aside.
6. Remove brush belt from end of brush and
set aside. If worn or damaged, replace with
new brush belt.
7. Remove pump belt and replace it with
a new belt by pinching belt at one end to
make a large loop. Attach belt to silver
motor shaft first and then pull towards larger,
red pulley. Attach belt to red pulley.
NOTE: Spinning the red pulley a few times
will help center belt and ensure correct
assembly.
8. Reattach brush belt by installing onto
toothed pump pulley and then onto toothed
end of brush.
9. Reattach belt access door assembly
to end of brush and rotate back into place.
Replace screws.
NOTE: Do not over tighten screws.
If you have any questions or are having
trouble removing, replacing or reinstalling
your brush belt, please contact BISSELL.
www.BISSELL.com
10