Panasonic MC-E4061-00 Service Manual page 7

MC-E4061-00
3.9. Motor Assembly Replacement
3.9.1. Removal
1. Remove the dust cover by removing the eight (8) screws.
2. Remove the lower plate, beater bar assembly, belt, the
plastic shaft and the nozzle housing as instructed in the
respective removal sections.
3. Disconnect the motor leads and remove the motor. Remove
the motor support rubber (rear), motor cap, noise
suppressor and the motor support rubber (front).
3.9.2. Installation
1. Place the motor back into the dust compartment with the
tabs on the motor support (rear) aligned parallel to the front
edge of the dust compartment.
2. Rewire per the Pictorial Wiring Diagram and Wiring
Management Drawing.
3. Replace the dust cover and the eight (8) screws.
4. Replace the nozzle housing assembly, belt, beater bar
assembly, and lower plate according to the respective
installation instructions.
14