Operating the appliance
en
Notes
If there is a high water level, high
■
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
Õ is lit ~ Reloading is not
possible. To continue the
programme, select the
Reload button.
Do not open the door until the door
■
lock symbol Õ goes out.
Do not leave door open for
■
a prolonged period – water could
run out of the laundry.
The reloading function cannot be
■
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Select
1.
Start/Reload.
A
Select another programme. If
2.
required, adjust the default settings
and/or select additional functions.
Select
Start/Reload. The new
3.
A
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
Select
1.
Start/Reload.
A
To cool down laundry: Select Rinse
2.
O.
Select
3.
Start/Reload.
A
For programmes at low temperature:
Select
1.
Start/Reload.
A
Select Spin/Drain 0/[.
2.
Select
3.
Start/Reload.
A
18
Start/
A
For drying programmes:
Select Intensive Dry 5 or Gentle
1.
Dry ‰.
Touch button Š Dry and set drying
2.
time to 15 minutes.
Select
3.
Start/Reload.
A
End of the programme
End or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal ~ Page 27
If – – – – (Rinse stop = without final
drain/spin cycle) was selected, press
Start/Reload button to start the final
A
drain/spin cycle.
Notes
The programme continues by
■
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
If only the water is to be pumped out,
■
approx. 1 minute after the
programme starts, touch the
Start/Reload button before the spin
cycle starts. The programme is
interrupted and the door lock is
released. The laundry can be
removed.
If Hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
A