Starting the programme
Touch and hold A button for 1~2
seconds, then release the button. The
programme starts and the appliance
door is locked.
The Finish in time is shown in the
Touch-Display and counts down until
the programme starts. After the
programme has started, the programme
duration is displayed. And the displays
for the programme's progress light up.
~ "Touch-Display" on page 25
Note:
Foam detection
If the symbol Å also lights up in the
Touch-Display, the appliance has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
If you want to lock the programme to
prevent it from being adjusted
inadvertently, you can select the
childproof lock.
Childproof lock
You can lock the appliance to prevent
the functions you have set from being
changed inadvertently. To do this,
activate the childproof lock.
To activate the childproof lock:
After the programme starts, Touch and
hold the E (3 ) button for 3 seconds.
E (3 ) lights up: The childproof
■
lock is activated.
E (3 ) flashes: If the programme
■
and programme settings are
adjusted while childproof lock is
activated.
When the programme ends, End
Note:
is displayed. The door is unlocked. E (3
) remain on to remind you to
deactivate the childproof lock.
Operating the appliance
To deactivate the childproof lock:
Touch and hold the E (3 ) button until
the E (3 ) indicator lamp is off.
Adding/removing laundry
After starting the programme, you can
add or remove laundry if necessary.
Touch the A button. The appliance
checks whether reloading is possible.
If the following appears on the Touch-
Display:
The symbol Õ disappears,
■
reloading is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
A button. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the A button.
1.
Select another programme.
2.
And touch the A button again. The
3.
new programme starts from the
beginning.
If drying is activated, you have to
Note:
switch the appliance off and on again to
change the drying programme.
en
39