if you come into contact with hot water
(e.g. when draining hot water into a
washbasin).
Do not reach into the hot water.
Caution!
Water damage
If the drain hose slips out of the
washbasin or the connection point
during draining due to high water
pressure, any escaping water may
cause water damage.
Secure the drain hose so that it cannot
slip out.
Caution!
Damage to the appliance/fabrics
If the end of the drain hose is immersed
in the drained water, water may be
sucked back into the appliance and
may damage the appliance/fabrics.
Make sure that:
The plug does not block drainage
■
from the washbasin.
The end of the drain hose is not
■
immersed in the drained water.
The water drains away quickly
■
enough.
Do not kink the water drain hose
Note:
or put strain on it lengthways.
Connection
Drainage into a washbasin
■
Drainage into a siphon
■
The connection point must be
secured using a hose clamp with a
diameter of 24 - 40 mm (available
from specialist dealers).
Positioning and connecting
Drainage into a plastic pipe with
■
rubber bushing or into a drainage
pit
Alignment
Loosen the lock nut in a clockwise
1.
direction with a wrench.
Check the alignment of the washer
2.
dryer with a spirit level and, if
required, correct. Adjust the height
by rotating the appliance foot.
All four appliance feet must
Note:
be firmly on the floor.
The washer dryer must not wobble!
Tighten the lock nut against the
3.
housing.
Grip the foot and do not adjust the
height.
Notes
The lock nuts on all four appliance
■
feet must be screwed tightly against
the housing!
Any loud noises, intense vibrations
■
or "wandering" may be due to
incorrect alignment!
en
41