Contents 5.2 Using additional microphones Welcome Special functions Getting to know your Roger Table Mic 6.1 Muting 2.1 In the box 6.2 Disconnecting Roger devices (NewNet) 2.2 How Roger Table Mic works 2.3 Device descriptions Troubleshooting 2.4 Indicator lights Important information Getting started 8.1 Important safety information...
Congratulations on choosing the Roger Table Mic from the possibilities Roger Table Mic offers. Phonak. Roger Table Mic is a wireless microphone for full participation in small and big meetings. You simply place If you have any questions, please consult your hearing it on the table.
RCA / Cinch adapter Soft case Listener Speaker Roger Table Mic and the hearing aids typically work within a range of up to 30 meters / 100 feet. Note that Quick Setup Guide human bodies and walls may reduce this distance. The furthest range is possible when you can see Roger Table Mic (i.e.
Connect Charging e Charging input Fully charged f Audio input Low battery – charge Roger Table Mic Roger Table Mic has lost connection to the other Roger microphone(s). Press the Connect button to reinitialize the network. Remote control a Indicator light...
3. Getting started 3.1 Setting up the power supply Remove / Change: 1. Pull back the tab on the universal The universal power supply comes with an adapter for power supply. your country. To charge your device you first need to attach the correct adapter to the power supply.
2 hours. Charging is complete when the indicator light turns solid green. When charging Roger Table Mic for the first time, let it charge for at least two hours, even if the battery indicator light is not lit or turns green earlier.
You can also charge Roger Table Mic by connecting it 3.4 Switching on and off to a computer’s USB port using the supplied charging cable. To switch Roger Table Mic on, press the on/off button for one second until the indicator light turns Indicator lights (battery status) green.
T / MT / T-Coil mode. both powered on. The Roger MyLink User Guide provides more detailed 2. Hold Roger Table Mic within 10 cm / 4 inches of the information on using Roger MyLink. Roger receiver.
You can connect an infinite number of Roger receivers to Roger Table Mic. 1. Press and hold any button on the remote control. Indicator light (connection status) 2. Start the Roger Table Mic by pressing the on/off After pressing the Connect button, the following button.
- to hear its audio signal directly in your hearing aids. Place Roger Table Mic in the middle of a table to listen to a group of people. 1. Connect one end of the...
5.1 Connect It’s possible to add up to 10 other Roger microphones to Roger Table Mic. To connect another microphone to your Roger Table Mic, follow these steps: If you want to connect a Roger Pen to Roger Table Mic, press Connect on the Roger Pen instead of 1.
20 cm / 8 inches). Roger microphone is now connected to Roger Table Mic. The Roger microphones automatically detect when Roger Table Mic could not find another someone talks, before instantly transmitting the voice to Roger microphone. Move Roger Table Mic your hearing aids.
1. Firmly press the on/off Roger Table Mic has lost connection to on the remote control to mute Roger Table Mic’s the other Roger microphone(s). Press the microphone or audio input. Connect button to reinitialize the network.
The indicator light will 7 secs dirt or an object turn orange when Roger I cannot hear the speaker’s voice even though Roger Table Mic is Table Mic has been dis- switched on connected from all J The microphone has been J Check the indicator light –...
Table Mic and Roger receiver is Table Mic on/off and Connect button too large I am not able to connect my Roger Table Mic with another Roger J There are obstacles between J Make sure you can see the microphone you and Roger Table Mic Roger Table Mic (line of sight)
Your device should only be repaired by an authorized consequences for the environment and human health. service center. Changes or modifications to this device that were not explicitly approved by Phonak are not permitted. Please dispose of electrical components in accordance with your local regulations.
IECXXXXX standards. Protect the device from excessive shock and vibration. Only use accessories that are approved by Phonak AG. Do not expose your device to temperatures and humidity outside of the recommended conditions Using your device’s cables in any way contradictory to...
Protect the device from excessive moisture (bathing, The device has a built-in rechargeable battery. This swimming), heat (radiator, car dashboard), and direct battery can be charged and discharged hundreds of contact with skin when sweating (workout, fitness, times but may eventually wear out. The battery may sport).
9.2 International warranty and void. This warranty does not cover any services performed by a hearing care professional in his / her Phonak offers a one year limited international warranty, office. valid as of the date of purchase. This limited warranty covers manufacturing and material defects.
The CE symbol is confirmation by functions without problems or Phonak Communications AG that restrictions if used as intended, unless this Phonak product is in compliance otherwise noted in these user guides. with the essential requirements and other relevant provisions of Directive Australian EMC and Radiocom- 1999/5/EC.
Page 22
The symbol with the crossed-out garbage bin is to make you aware that this device may not be thrown away as normal household waste. Please dispose of old or unused device, at waste disposal sites intended for electronic waste, or give your device to your hearing care professional for disposal.
Need help?
Do you have a question about the Roger Table Mic and is the answer not in the manual?
Questions and answers