Unitech PA700 User Manual

Unitech PA700 User Manual

Rugged handheld computer
Hide thumbs Also See for PA700:

Advertisement

PA700 Rugged Handheld Computer
User's Manual
Version 1.1

Advertisement

Table of Contents
loading

Summary of Contents for Unitech PA700

  • Page 1 PA700 Rugged Handheld Computer User’s Manual Version 1.1...
  • Page 2: Preface

    –Consult the dealer or an experienced radio/TV technician for help. This transmitter must not be co-located or operating in conjunction © 2015 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
  • Page 3 Interference-Causing Equipment Regulations. Cet appareil numerique de la classe B respecte les exigences du Reglement sur le material broilleur du Canada. © 2015 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
  • Page 4: Rohs Statement

    European Conformity Statement unitech Electronics co., Ltd herewith declares that the unitech product is in compliance with the essential requirements and all other provisions of the R&TTE 1999/5/EC directive, the EMC 2004/108/EC directive and the Low Voltage 2006/95/EC directive. The declaration of conformity is available for download at : https://portal.unitech.eu/public/Safetyregulatorystatement...
  • Page 5 Taiwan NCC Warning Statement 交通部電信總局低功率電波輻射性電機管理辦法 第十二條:經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者 均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 第十四條:低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有 干擾現象時,應立即停用,並改善至無干擾時方得繼續使用。 低功率射頻電機需忍受合法通信或工業、科學及醫療用電波輻射性電機設備 之干擾。 注意事項: 1. 使用過度恐傷害視力。 2. 使用30分鐘請休息10分鐘;2歲以下幼兒不看螢幕,2歲以上每天看螢幕不要超過 1小時。 © 2015 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
  • Page 6 Laser Information The unitech product is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 825-1. Class II and Class 2 products are not considered to be hazardous. The unitech product contains internally a Visible Laser Diode (VLD) whose emissions do not exceed the maximum limits as set forth in the above regulations.
  • Page 7 It may not be functional anymore. Please only use the original battery from unitech. Using a third party battery can damage our products. Please note that when such damage occurs, it is not covered by your warranty.
  • Page 8 Please follow the limitation of suggested temperature conditions to avoid failure, damage or malfunction. *For applicable temperature conditions, please refer to the specification of each product. © 2015 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
  • Page 9 Please remove the power adapter when the battery is fully recharged. The bundled power adapter that comes with your unitech product is not meant to be used outdoors. An adapter exposed to water or rain, or a very humid environment can cause damage to both the adapter and the product.
  • Page 10: Worldwide Support

    Worldwide Support unitech’s professional support team is available to quickly answer questions or assist with technical-related issues. Should an equipment problem occur, please contact the nearest unitech regional service representative. For complete contact information please visit the Web sites listed below: Taipei, Taiwan –...
  • Page 11: Warranty Policy

    The warranty period is varied from each country. Please consult with your supplier or unitech local office for actual length of warranty period to your purchased product. Warranty becomes void if equipment is modified, improperly installed or used, damaged by accident or neglect, or if any parts are improperly installed or replaced by the user.
  • Page 12: Table Of Contents

    2. Getting started ...................2 2.1 Device overview ...................2 2.2 Assembly ....................4 Accessing battery, Micro SD card and SIM card........4 Put battery back to PA700 ..............5 2.3 Charging the battery ................6 2.4 Data Communicating with PC Device...........7 2.5 LED status....................7 2.6 To check the battery level and to access the battery usage menu ..8 3.
  • Page 13: Package Contents

    1. Package Contents USB cable PA700 (Standard USB to Micro USB) Charger Battery Power Plug Adapter Hand Strap...
  • Page 14: Getting Started

    2. Getting started unitech PA700 is an Android platform device. Android platform device has great flexibility that allows you to make customized configurations and enhancements by install and remove Apps. With Android operation system, your device has limitless possibilities to update to latest features and improvements.
  • Page 15 13. Bar Code Scan Engine 15. Volume Down Button 14. Scan Button 16. Volume Up Button 17. Micro USB port 19. Power button 18.Earphone jack 20. Scan button...
  • Page 16: Assembly

    2.2 Assembly Accessing battery, Micro SD card and SIM card 1. Using a proper tool (ex. a coin) to loosen the two screws on the battery cover by turning counterclockwise. 2. Remove the back cover and pull the battery out. 3.
  • Page 17: Put Battery Back To Pa700

    Put battery back to PA700 1. Using a proper tool (ex. a coin) to loosen the two screws on the battery cover by turning counterclockwise. 2. Put battery into battery compartment and put back cover . 3. Using a proper tool (ex. a coin) to tighten the two screws on the battery...
  • Page 18: Charging The Battery

    2.3 Charging the battery Connect PA700 to the charger, it will be charged automatically. 1. Connect the standard USB connector to the charger. 2. Connect the micro USB connector to the micro USB port at the bottom. 3. Plug the AC charger into a wall outlet. If needed, attach a plug converter...
  • Page 19: Data Communicating With Pc Device

    2.4 Data Communicating with PC Device 1. Connect the standard USB connector to the USB port of the PC device. 2. Connect the micro USB connector to the micro USB port at the bottom. 2.5 LED status ■ The battery is fully charged Green ■...
  • Page 20: To Check The Battery Level And To Access The Battery Usage Menu

    2.6 To check the battery level and to access the battery usage menu 1 From your Home screen, tap 2 Find and tap Settings.
  • Page 21 3 Find and tap Battery.
  • Page 22: Basic Operation

    3. Basic Operation 3.1 Accessing and using applications To open the Application screen From your Home screen, tap To browse the Application screen From the Application screen, flick right or left. To create a shortcut to an application on the Home screen 1 From your Home screen, tap 2 Touch and hold an application icon and then the Home screen opens.
  • Page 23: Barcode Scanning (For Imager Version Only)

    3.2 Barcode Scanning (For Imager Version only) 1. Tap the ScanService 2. Aim the Bar code Scan Engine to the barcode and press one of two scan buttons.
  • Page 24: Rfid Sensing

    3.3 RFID Sensing 1. Tap the ScanService 2. Place NFC reader near the tag to read the information.
  • Page 25: Mobolink App Setting

    3.4 MoboLink App Setting MoboLink is a software platform that helps unitech customers to remote manage their purchased devices and applications. The core of the MoboLink platform provides functionalities in the MDM (Mobile Device Management) and MAM (Mobile Application Management) domains, and then further extends into other management functions such as alert notification management and account management.
  • Page 26 3. MoboLink app screen information is as below: To switch on/ off MoboLink app, slide On/Off button. Then tap “Exit” to leave the screen. Note: If this app is on, it will jump out on the screen when the device is offline. Please visit the support page to know more about MoboLink.
  • Page 27: Specification

    4. Specification System Features TI OMAP 4470 1.5Ghz Dual Core Processor 1GB Mobile DDR RAM Memory 8GB eMMC Flash Android 4.3 Jelly Bean English, Simp. Chinese, Traditional Chinese, Japanese, Languages support Spanish, German, French and multiple languages Display Gorilla Glass II with 5-point capacitive touch panel 4.7"...
  • Page 28 PDF417 2D Imager MicroPDF417 (2D is only available when the 2D imager Code 128 Emulation is on your device ) Data Matrix Data Matrix Inverse Decode Mirror Images (Data Matrix Only) Maxicode QR Code QR Inverse MicroQR Aztec Aztec Inverse Audio 1W speaker 85 dB at 10cm , 3.5mm Audio Jack, Receiver, Microphone Regulatory Approvals...
  • Page 29 1 hour Backup Battery capacity Enclosure 285g (with battery) Weight Dimension 160mm x17.4mm x 80mm ( without engine ) Environmental Operating temperature 14°F to 122°F (-10°C to 50°C) -4°F to 140°F (-20°C to 60°C) Storage temperature Charging Temperature 32°F to 104°F (0°C to 40°C) Relative Humidity 5% ~ 95% ( non-condensing ) 1.2 meter...

Table of Contents