Philips GC4310 Service Manual page 2

DISASSEMBLY ADVICE
THERMOSTAT DIAL ASSY 1
RATTLE SPRING 2
BACKPLATE ASSY 3
CORDSET 4
BALL SWIVEL 5
Remove Screw A
Remove Screws B1, B2
FILLING DOOR 6
INLAY 7
SOS KNOB 11
SPRAY KNOB 12
LAMP ASSY 13
Remove Screw A
Remove Backplate assy 3
STEAM SLIDER 9
DOSING ASSY 10
TANK SEAL 14
HOUSING 15
AESTHETICS RING 16
SPRAY NOZZLE ASSY 18
PUMP ASSY 19
THERMOSTAT BUSH 20
WATER TANK ASSY 21
Remove Screw A
Remove Backplate assy 3
Remove Inlay 7
Remove SOS knob 11
Remove Spray knob 12
Remove Screws C1, C2
Remove Dosing assy 10
Remove Thermostat dial assy 1
Remove Screws D1, D2
Remove Screws E1, E2
Remove Housing 15
Remove Screws F1, F2
Remove Water tank assy 21
REPAIR INSTRUCTIONS
- Due to the high voltage of the iron, ONLY the specified cordsets must be used.
- Thermostat (Pos 101) fitted to the soleplate (Pos 26) was pre-adjusted by the
suppliers and secured by glue. To avoid mal-function of the iron, NEVER adjust
the thermostat.
- No information about the type number and voltage is stamped onto the typeplate.
When replacing the back plate (typeplate is at the bottom), engrave at least the type
number & voltage on the typeplate with a sharp object.
- Parts with numbers from 100 and higher cannot be ordered separately.
OPTIONAL (accessories)
- No specific issues
GC4310
COVER 22
RYTON RING 23
SOS SEAL 24
DOSING SEAL 25
SOLEPLATE ASSY 26
Remove Screw A
Remove Backplate assy 3
Remove Inlay 7
Remove SOS knob 11
Remove Spray knob 12
Remove Screws E1, F1, F2
Remove Water tank assy 21
Remove Screws G1, G2, G3
Remove Heat shield
Remove Cover 22
2-4