Advertisement
0-7-0 042MF231D/370
Back to cover
- Even if the panel glass is cleaned before shipping, there is a possibility of particle remained on the panel. In
this case, remove it prior to the usage. When you clean the surface of the panel glass, use a piece of soft
cloth with detergent to wipe off. Do not use any chemical substances such as acid, alkali or organic
detergent.
- The Module is composed of various kinds of materials such as glass, metals and plastics. A qualified service
technician is required for the disposal of the Module.
- Do not set the Module on an unstable, vibrating or inclined place. The Module may fall or collapse and it may
cause a serious injury to a person, and/or damage to the product.
- If you need to remove the Module to another place, you must turn off the power supply and detach the
interface cable and power cable from the Module beforehand, and watch your steps not to step on the
cables during the operation. If the cables are damaged during the transport, it may result in fire hazard or
electric shock. Also if the Module is dropped or fallen, it may cause a serious injury to a person and /or
damage to the product.
- When you draw or insert the module's cable, you must turn off the power supply and do it (with) holding the
connector. If you forcibly draw the cable, the electric wire in the cable can be exposed or broken. It may
result in fire hazard or electric shock.
- When you carry the Module, it should be done with at least two workers in order to avoid any unexpected
accidents.
- Be careful not to touch the panel glass surface while the PDP module is operating because there is a
possibility of getting a burn injury due to its very high temperature.
- The Module has a glass-plate. If the Module is inflicted with excessive stress – for example; shock, vibration,
bending or heat-shock, the glass plate could be broken. It may result in a personal injury. Also, do not press
or strike the glass surface.
- If the glass panel was broken, do not touch it with bare hand. It may result in a cut injury.
- Do not place any object on the glass panel. It may be the cause of the scratch or break of the glass panel.
- Do not place any object on the Module. It may result in a personal injury due to fall or drop.
- PDP is a product, which generates heat during operation. Therefore, do not use the materials which make
corrode the PDP module by the chemical reaction that takes place in high temperature and humidity
conditions.
- Exposing to corrosive gases or contact with the materials, which may cause corrosions, could lead to
chemical reactions that will adversely affect on the device. If you were to use the PDP in such conditions,
consider ways to avoid such exposure or to protect the PDP module.
CAUTION
Advertisement
