Error Codes - LaserLiner LaserRange-Master X2 Operating Instructions Manual

Technical Data
Inside measurement range
Precision (typical)
Laser class
Laser wavelength
Power supply
Dimensions
Weight (incl. batteries)
Automatic switch-off
Operating temperature
Storage temperature
Article number
* measuring distance up to 10 m with strongly reflective target
surface and at room temperature. The measurement deviation
may increase by +/-0.2 mm/m for greater distances and under
unfavourable measuring conditions such as strong sunlight or
weakly reflective target surfaces.

Error codes:

301: Target is outside measuring range.
302: Target is too dark or too much ambient light. Use
a reflecting material as target for the measurement.
303: Measured value cannot be shown by LC display.
Set measured values to zero with button (4.).
304: Pythagoras parameter error
305: Replace the battery.
306: Temperature is too low: < 0 °C
307: Temperature is too high: > 40 °C
308: Too much ambient light.
EU directives and disposal
This device complies with all necessary standards
for the free movement of goods within the EU.
This product is an electric device and must be
collected separately for disposal according to
the European Directive on waste electrical and
electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
LaserRange-Master X2
(Subject to technical changes without notice)
0,5 m - 25 m
± 3 mm / 10 m*
2 < 1mW
650 nm
2 x AAA 1.5 Volt batteries
110 x 43 x 28 mm
110 g
30 sec LCD lighting /
45 sec laser / 3 min device
0°C – 40°C
-20°C – 70°C
080.944A
15
GB