Table of Contents
Advertisement
SECTION 2
7 Connecting a Mouse
Connecting a USB mouse
1
Plug a mouse in the USB port on the back of your computer.
Insert the plug with the face marked with
(Your computer or situation may not look exactly like this illustration.)
Critical Points
A USB mouse can be connected to and disconnected from your computer at any time
without shutting down the computer.
By default, Flat Point is set up so that connecting a mouse will not automatically disable it. If
you want to disable Flat Point, see "Disabling Flat Point."
Disabling Flat Point
Connecting a USB mouse enables you to use two pointing devices at the same time: USB
mouse and Flat Point. However, if you want to use only the mouse, follow these steps to disable
Flat Point.
1
Press the [
] key while holding down the [
Each time you press the [
The message "Internet pointing device: Enable" is displayed when Flat Point is enabled, while
the message "Internet pointing device: Disable" is displayed when it is disabled.
IMPORTANT
•
Before disabling Flat Point, be sure to connect a USB mouse to your computer.
100
USB port
] key, Flat Point is switched back and force between on and off.
up.
] key.
Advertisement
Table of Contents
