Advertisement
1
2
3
6
7
8
1
2
1
2
11
12
13
D
RY-vACUUm OpERAtiON
WARNiNG: BE SURE tO READ, UNDERStAND, AND AppLY iNFORmAtiON,
ENtitLED 'SAFEtY iNStRUCtiONS & WARNiNGS'. DO NOt vACUUm iN
AREAS WitH FLAmmABLE GASES, vApORS, OR ExpLOSivE DUStS iN tHE
AiR. FLAmmABLE GASES OR vApORS iNCLUDE BUt ARE NOt LimitED tO;
LiGHtER FLUiD, SOLvENt tYpE CLEANERS, OiL-BASE pAiNtS, GASOLiNE,
ALCOHOL OR AEROSOL SpRAYS. ExpLOSivE DUStS iNCLUDE BUt ARE NOt
LimitED tO; COAL, mAGNESiUm, GRAiN OR GUN pOWDER. tO REDUCE
tHE RiSK OF HEALtH HAZARDS FROm vApORS OR DUSt, DO NOt vACUUm
tOxiC mAtERiALS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. In order to prepare your vacuum for dry vacuuming, verify that the cartridge filter
is securely mounted. Make sure the filter is pushed in until it stops against the
power head. (fig. 2) (Your Wet/Dry Vac comes with the cartridge filter pre-installed,
if not see page 9 for installation instructions.)
3. Place filter retainer on top of cartridge filter and tighten by turning the retainer
handle clockwise. (fig. 3)
4. Optional, for improved dust filtering, fit collection dust bag flange onto the inlet
4
5
5. Place the power head back on the container, aligning the top section with the
OPERATING INSTRUCTIONS: DRY VACUUMING
6. Insert the locking end of the hose into the vacuum port on the power head and
9
10
7. Verify that the switch is in the 'O' OFF position before plugging the power cord into
8. Turn the motor on by flipping the switch to the 'I' ON position. (fig. 9)
14
15
9. Once you have completed vacuuming, flip the switch to the 'O' OFF position and
10. To rewind the cord, hold on to the plug and press the cord rewind button. Do not
O = OFF
DO NOt USE tHE CARtRiDGE FiLtER FOR LiQUiD vACUUmiNG.
1
6
11
stub, taking care not to damage the bag. (fig. 4)
latches, and lock into place. (fig. 5)
screw in place. Push the desired extension wands or attachments onto the free end
of the hose. (fig. 6)
the outlet. (fig. 7 & 8)
unplug the power cord from the outlet. (fig. 10 & 11)
allow plug to whip when rewinding. (fig. 12)
I = ON
2
3
7
8
12
4
5
9
10
Advertisement
