Daewoo KOT-123Q0A Service Manual page 14

1) Remove four screws which secure the control panel,
push up snap fits and draw forward the control panel
assembly.
2) Disconnect all the lead wires connected to control panel
assembly.
3) Remove the door open lever from the control panel.
4) Remove four screws which secure the PCB assembly to
control panel.
5) Disconnect membrane tail from the connector of the
PCB assembly.
6) Detach membrane from the control panel.
7) Remove door open button and button spring from the
control panel.
8) Reverse the above steps for reassembly.
6. TO REMOVE HIGH VOLTAGE CAPACITOR
1) Remove a screw which secure the grounding ring terminal of the H.V. diode and the capacitor holder.
2) Remove the capacitor holder with the capacitor.
3) Reverse the above steps for reassembly.
DISASSEMBLY AND ASSEMBLY
High voltage circuit wiring
13