4. METHOD TO REDUCE THE GAP BETWEEN THE DOOR SEAL AND THE OVEN FRONT SURFACE
1) To reduce gap located on part ' A' .
Loosen two screws on stopper hinge top, and then push
•
the door to contact the door seal to oven front surface.
Tighten two screws.
•
2) To reduce gap located on part ' B' .
Loosen three screws on stopper hinge top, and then
•
push the door to contact the door seal to oven front
surface.
Tighten three screws.
•
3) To reduce gap located on part ' C' .
• Loosen a screw on interlock switch assembly located
top of oven body.
• Draw the interlock switch assembly inward as possi-
ble to engage with hook on the door bottom.
Tighten a screw.
•
4) To reduce gap located on part ' D' .
• Loosen a screw on interlock switch assembly located bottom of oven body. And (4) are same as step (3).
NOTE
A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
DISASSEMBLY AND ASSEMBLY
11
.
2