Cast Tec Integra Convector Plus Installation And User Instructions Manual page 14

COAL LAYOUT
CONTINUED
Fig. 18
Fig. 19
Fig. 20
Small Coal
Fig. 21
14
5. Pick out the smallest two coals and lay to one side,
lay the first row of four loose coals on top of the front
coal. Ensure the back of the coals are resting on the
coal bed and there are even gaps all round (Fig. 18).
6. Choose three loose coals and place them in line on
the next row up, again making sure all the gaps are
even. It is important that the coals 'bridge' the peaks of
the fuel bed and are not placed in between. This helps
the flow of burnt gases and should give an even
glowing fuel bed (Fig. 19).
7. Lay another row of four coals on the next row up,
again making sure all the gaps are even (Fig. 20).
8. Place the next three coals in the middle, on the back
edge of the coals previously laid ensuring even gaps all
round. Finally place the two small coals, one in each
top corner. Make any adjustments necessary to achieve
even gaps as this will help in giving a well balanced
flame picture and an even glow (Fig. 21).
Small Coal