Table of Contents
Advertisement
Removing an SFP+ module
To remove an SFP+ module, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Read the information in "Handling an SFP+ module" on page 11.
3. Remove the fiber-optic cable from the SFP+ module that you want to replace.
4. Unlock the SFP+ module by pulling the wire tab straight out, as shown in the
5. Grasp the wire tab on the SFP+ module and pull it out of the port.
6. Replace the protective cap on the SFP+ module.
7. Place the SFP+ module into a static-protective package.
on page 5.
For more information about removing the cable, see "Disconnecting the SFP+
module cable" on page 16.
Attention:
To avoid damage to the cable or the SFP+ module, make sure that
you disconnect the fiber-optic cable before you remove the SFP+ module.
following illustration.
Chapter 3. Installing and removing a 10 Gb SFP+ module
13
Advertisement
Table of Contents
