Bosch GLI 10,8 V-LI Professional Operating Instructions Manual page 17

OBJ_BUCH-234-003.book Page 17 Wednesday, August 29, 2007 8:34 AM
To remove the battery 5, press the battery unlocking buttons 6 and pull the
battery out of the cordless worklight toward the rear. Do not exert any
force.
The battery is equipped with a NTC temperature control which allows
charging only within a temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this manner.
Observe the notes for disposal.
Operation
Starting Operation
Inserting the Battery
Use only original Bosch lithium ion batteries with the voltage
listed on the nameplate of your cordless worklight. Using other
batteries can lead to injuries and pose a fire hazard.
Insert the charged battery 5 into the handle until it can be felt to engage
and faces flush against the handle.
Switching On and Off
The cordless worklight produces a light beam that emerges
from the lamp head 1.
To start the cordless worklight, press the On/Off switch 3.
To switch off the cordless worklight, press the On/Off switch 3 again.
Protection Against Deep Discharging
The lithium ion battery is protected against deep discharging by the "Elec-
tronic Cell Protection (ECP)". When the battery is empty, the cordless
worklight is switched off by means of a protective circuit.
1 609 929 K23 • 29.8.07
English | 17