Operation; Maintenance - Makita GD0800C Instruction Manual

To remove the wheel point, follow the installation
procedure in reverse.
8mm(5/16")Max.
003495
CAUTION:
Use the correct size collet cone for the wheel point
•
which you intend to use.

OPERATION

003497
Turn the tool on without the wheel point making any
contact with the workpiece and wait until the wheel point
attains full speed. Then apply the wheel point to the
workpiece gently. To obtain a good finish, move the tool
in the leftward direction slowly.
CAUTION:
Apply light pressure on the tool. Excessive
•
pressure on the tool will only cause a poor finish
and overloading of the motor.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Wheel points
•
Collet cone set (3 mm, 6 mm, 1/4", 1/8")
•
Vise holder
•
Wrench 13
•
Wrench 19
•
Side handle set
•
7
or attachments
Only use accessory or
are