Installing The Ilook+ 1080P Camera With 5.8Ghz Video Link; Motor Unlock; Motor Lock - devention scout x4 Quick Start Manual

r
Ith
8.5 Make sure the gimbal move f eely in all directions.
The G-3D gimbal is now successfully installed.
9.0 Installing the iLook+ 1080p camera with 5.8ghz video link
9.1 Screw the short "mushroom"
antenna into the camera, use the
included wrench to gently secure
the antenna, do not use force.
9.2 Release the two M2x4 screws
securing the camera mounting
bracket.
9.3 Install the camera into gimbal,
Fix it with camera fixed frame
(ensure the gap close to the
lens), then screw the M2x4
screw to the camera fixed
frame again.
9.4 Connect the cameras power
cable to the power port on the
G-3D gimbal controller.
9.5 The iLook+ camera is now successfully
installed in your G-3D gimbal.
10.0 Motor Unlock
After succeeding in binding the code, under the stable mode, put the throttle control ball in the lowest position, and stir the direction control ball to the far left.
When the red LED indicator turn solid red, it means that the motor is unlocked. In this condition, if you turn upward the throttle control ball, the motor will run.
Note: For safety, the motors will automatically lock after 10 seconds. This means, if you do not start flying in 10 seconds,
you have to unlock the motors again.
11.0 Motor Lock
Put the throttle control ball in the lowest position and stir the direction control ball to the far right. When the red LED indicator light out, it means that
the motor is locked. In this condition, if you turn upward the throttle control ball, the motor will not run.
• 5 •