Compass Calibration; G-3D 3-Axis Brushless Gimbal Installation - devention scout x4 Quick Start Manual

The red LED light out
te'
i
ad vertical
Ground
down
7.5 NOSE DOWN rotation. Rotate
the aircraft facing the nose down.
rotate smoothly in 90 deg increments.
Pausing 1 second for each 90 deg.
(0 / 901180 1 270 I 360)
7.6 Put aircraft to the horizontal position,
the red LED light out which means
calibration finished. pleasereconnect
the aircraft power after calibration.
7.0 Compass Calibration
In the main screen, touch IN icon then touch mode to enter stick control and setting screen.
Compass calibration icon
IMPORTANT:
Make sure the motors are locked before calibration (Aircraft red LED indicator is NOT flashing). Factory default setting, is for the
motors to be locked after the completed ID binding process. (For details on motor lock and unlock process see point 10 and 11)
7.1 Touch the icon and enter
compass calibration. The red
LED of the aircraft will flash
rapidly.
7.2 FORWARD rotation. Rotate
tilting the aircraft forward rotate
smoothly in 90 deg increments.
Pausing 1 second for each 90
deg.(0 / 90 / 180 / 270 / 360)
7.3 CLOCKWISE rotation. Rotate
the aircraft around the roll axis rotate
smoothly in 90 deg increments.
Pausing 1 second for each 90 deg.
(0 / 90 / 180 /270 / 360)
7.4 HORISONTAL rotation. Rotate
the aircraft around the YAW axis
rotate smoothly in 90 deg increments.
Pausing 1 second for each 90 deg.
(0 /90 / 180/270 1 360)
IMPORTANT: The first couple of flights, you may expereince the
aircraft drifting,
This is normal, please continue to fly the aircraft manually, while the
system inprove the calibration, after 5-10 minutes land, lock the motors,
this will save the improved settings.
Notice: The slight drifting may continue for a couple of batteries, you
will notice significant improvement in the GPShold & stability
after 4-5 batteries.
Notice: Always perform the calibration away from eletric fields and
metal surfaces.
Trivia: Different brands have different calibration processes, the
process is typically refered to as "the Calibration Dance".
8.0 G-3D 3-axis brushless Gimbal installation
IMPORTANT: REMOVE the battery from the Scout X4 while you install the gimbal
The gimbal is a high-performance eletromechanical design and should be handled with great care. AVOID using force when installing.
8.1 Prepare the G-3D gimbal,
M3x12 screw, spring.
8.2 Slide the gimbal unto the quik
mount rail, the gimbal shouldslide
from the front of the aircraft towards
the rear, gently move it as far back
as possible.
8.3 Install the springloaded
M3x12mm "finger screw" at the
front of the gimbal, this will
secure the gimbal.
8.4 Connect the 9pin white data
cable to the "complex data port"
on the bottom of the X4, then
connect the cable to the back of
the G-3D gimbal.
• 4 •