JVC MX-DVA5 Service Manual page 15

Removing the motor.
1.
Remove the two screws C fixing the motor.
Be careful to grease's splash when the
drive belt comes off.(Fig.4, Fig.5)
2.
Unsolder the motor terminal.(Fig.4)
Removing the mechanism board.
Unsolder the four parts a on the solenoid
1.
coil terminal.(Fig.4)
2. Remove the two screws D fixing the board.(Fig.4)
Unhook the three parts b from the board.(Fig.4)
3.
Remove the mechanism board.(Fig.4)
4.
Removing the flywheel.
Remove the cut-washers at c and d from the
capstan shaft, then remove the flywheel.
When reassembling the flywheel,
be sure to use new washers as they
cannot be reused. (Fig.7, Fig.8)
Flywheel
FR belt
Flywheel
Fig.7
Mecha.
board
b
a
D
Motor
Drive belt (Flat)
Capstan
washer
c
Sleeve
Washer
Flywheel
Fig.8
MX-DVA5
Motor
terminal
D b
C
a
C
Drive belt
Fig.4
Motor
Drive belt
Fig.5
Capstan
washer
Fig.6
d
Sleeve
FR belt
1-15