JVC MX-DVA5 Service Manual page 11

<CD/ DVD changer unit>
Prior to performing the following procedure, remove
the CD/ DVD changer unit.
Removing the DVD tray (See Fig.1 to 3)
1. Disconnect the card wire from connector SCW1 of
the CD servo board.
2. Turn the black loading pulley gear on the under side
of the CD/ DVD changer unit in the direction of the
arrow and draw the DVD tray toward the front until it
stops.
3.
Disconnect the card wire from connector LCW1 of
the CD/ DVD servo board on the upper side of the
CD/ DVD changer unit.
4.
Push down the two tray stoppers marked a and pull
out the DVD tray.
Reinstall the DVD tray (See Fig.4 and 5)
1. Align the gear-cam with the gear-tray as shown fig.3,
then mount the DVD tray.
2. When assembling the DVD tray, take extreme care
not engage with gear - synchro.
Gear-cam
Gear-convert
Gear-convert Gear-tray
Gear-tray
Gear-cam
timing point
Fig.4
Loading pulley
gear
CD/ DVD
servo board
SCW1
DVD tray
DVD tray
a
(Tray stopper)
Gear-tray
DVD tray
DVD tray
Fig.1
Fig.2
a (Tray stopper)
CD servo board
LCW1
Fig.3
Gear-synchro
Fig.5
MX-DVA5
1-11