Honeywell HZ-850 Series Manual page 5

OPERATION
(CONTINUED)
Model HZ-860 Series - EnergySmart
Ceramic Heater Operation
Turn heater on by pressing ON (
The heater will default to the Constant HI
mode and the Current Temp Indicator will
display the current room temperature.
The Energy Usage Indicator will display the
power consumption used by the heater.
The Energy Usage Indicator will display
STAND BY when the heater has reached the
Desired Room Temperature. At this point,
the heater is most efficient and is drawing
only a few watts of energy while in STAND
BY mode.
Energy Usage Indicator Status:
• If HI, the heater is drawing 1500 watts
to quickly warm the room
• If LO, the heater is drawing 750 watts
to slowly warm the room or maintain
the temperature
• In STAND BY, the heater is drawing
no power as the room has reached
the Desired Temperature
To set the heater, the digital control
is equipped with two (2) modes:
Constant Heat Mode -
there are two (2) heat settings
1. For Constant Low, press (
setting uses 750 watts of power
2. For Constant High, press (
setting uses 1500 watts of power
NOTE: Because the Low (
not require as much electricity to operate,
it is more energy efficient and may be a
better option if you are concerned about
the amperage draw on a circuit when the
heater is on the High (
) button.
); this
); this
) setting does
) setting.
™ ThermaWave
Model HZ-860
Energy Usage
Indicator
EnergySmart
™
Thermostat
Mode
Power
Light
Power Button
Model HZ-860C Canada
Energy Usage
Indicator
EnergySmart
™
Thermostat
Mode
Power
Light
Power Button
Current
Temp
Indicator
Continuous
Heat Mode
Current
Temp
Indicator
Continuous
Heat Mode
5