Table of Contents
Advertisement
CC220R
•
Go to SETTINGS / SECURITY / RESTRICTION.
•
Enter the base code, press OK.
•
Select an empty location (dashes) or a prefix to modify, press OK.
•
Enter the prefix using the keypad. Press OK.
- To activate restriction, select ACTIVATE.
- To deactivate restriction, select DEACTIVATE. Press OK.
9.5.5.
M
•
Go to SETTINGS / SECURITY / CHANGE CODE.
•
Enter the old base code using the keypad, press OK
•
Enter the new base code using the keypad, press OK.
•
Confirm by entering the new base code again, press OK.
9.6.
A
DVANCED SETTINGS
9.6.1.
S
•
Go to SETTINGS / ADVANCED SET. / SET BASE / REGISTR. MODE.
•
Your base light then starts to flash red rapidly.
•
Your base will remain in registration mode for about 1 minute.
You can also set the base to pairing mode by holding down your base's
button.
You can save up to four GAP-compatible handsets on your CC220R base.
9.6.2.
R
When you reset your base, all the base parameters are reset to their initial values (factory
settings).
•
Go to SETTINGS / ADVANCED SET. / SET BASE / RESET BASE.
•
Press Yes
•
Enter the base code. Press OK.
The "RE-INIT. IN PROGRESS message is displayed.
9.6.3.
D
•
Go to SETTINGS / ADVANCED SET. / SET BASE / DELETE HANDSET.
•
Select the handset you wish to unregister, press OK.
•
A screen prompts you to confirm the unregistration. Press Yes
handset.
9.7.
A
DVANCED SETTINGS
Before changing the settings of the telephone line, contact your operator to
obtain the parameters for your line.
ODIFYING THE BASE CODE
ET THE BASE TO PAIRING MODE
ESETTING THE BASE
.
-
E
REGISTERING A HANDSET
/ B
ASE SETTINGS
/ L
INE SETTINGS
28
to unregister the
Advertisement
Table of Contents
