Telephone Installation As A Wall Unit - SAGEMCOM CC220R User Manual

CC220R
- Remove the battery compartment cover.
• Remove the old batteries, insert the new batteries one by one in compliance with the
polarity of the batteries (refer to paragraph "Connecting the base", page 9).
• Refit the battery compartment cover.
Worn out batteries must be discarded, in accordance with the recycling instructions in chapter
Environment of this booklet.
To avoid damaging your handset, only use certified rechargeable AAA batteries
NiMH 1.2 V 450 mAh, never use non rechargeable batteries.
2.4. T
ELEPHONE INSTALLATION AS A WALL UNIT
• Swivel the grip clip. This prevents the handset from falling off its base.
• Mark the wall at the points where it is to be attached.
• Drill the holes in the wall at the points you have marked.
• Insert plugs into the holes if necessary.
• Place the phone on the wall-mounting base:
Align the arrow etched on the base (1) with the "wall position" mark etched on the
underside of the phone (refer to paragraph "Connecting the base", page 9).
Align the slots on the underside of the base with the hooks on the base (2).
Once the base and the base station are connected, slide the hooks into the
position (3).
• Hang the phone on the wall, align the wall grip slots with screws in the wall, and then
fold down firmly.
1
2
11
3