Updating Of The Firmware - Pioneer DJM-700-K Service Manual

5

5.2 UPDATING OF THE FIRMWARE

Purpose:
After replacement of the MAIN PCB Assy, updating of the firmware to the latest version is required.
Necessary software and tools
PC (With Windows 98, Me, 2000, or XP)
GGD1530 (Dedicated cable for connector conversion)
GGF1605 (Interface device: MINICUBE2)
QB-Programmer (software for updating) Refer to the next page.
Parameter file (To be used with QB-Programmer)
Firmware file
• You can obtain QB-Programmer and the parameter file from the website on the Internet. (See "How to Download the
Update Software.")
• You can obtain the firmware file from Niis on the Internet.
Connect either of the two terminals (for the main and sub-microcomputers) provided on the left side of the DJM-700 and
the terminal on the MINICUBE2 with the dedicated cable. Connect the PC on which updating software has been
installed and the MINICUBE2 with the USB cable supplied with the MINICUBE2.
Connections
Blind Cap
DJM-700
• Exterior view of the special cable
Part number : GGD1530
For connecting
to the DJM-700
The update target determines which terminal is used.
Update target
Main microcomputer, DSP
Sub microcomputer
Note: Turn off the DJM-700 before connecting it.
MINICUBE2 Setting
• Set the mode for the microcomputer to be updated.
Set the mode select switch to "M1" (left side)
Mode select Power select
switch
* Selecting "M1" allows you to update the DJM-700 microcomputer.
("M2" is used for another microcomputer and is not used at this time.)
• Select the power supply for the microcomputer that needs the update.
Set the power select switch to "3" (left side)
Mode select Power select
switch
5
6
Dedicated cable
Terminal to connect with
Left side
Right side
switch
switch
6
7
USB Cable
* Refer to the section "5.3 How to update."
DJM-700-S
7
8
A
B
Host machine
C
For
connecting to the
MINICUBE2
D
E
F
29
8