Other Methods Of Setting The Ip Address; Set The Ip Address With Arp/Ping - Axis P1311 Installation Manual

AXIS P1311 Installation Guide

Other methods of setting the IP address

The table below shows the other methods available for setting or discovering the IP address. All
methods are enabled by default, and all can be disabled.
Use in operating
system
Windows
UPnP™
MAC OSX
Bonjour
(10.4 or later)
All
AXIS Dynamic DNS
Service
All
ARP/Ping
All
View DHCP server
admin pages

Set the IP address with ARP/Ping

1. Acquire a free static IP address on the same network segment your computer is connected to.
2. Locate the serial number (S/N) on the AXIS P1311 label.
3. Open a command prompt on your computer and enter the following commands:
Windows syntax
arp -s <IP Address> <Serial Number>
ping -l 408 -t <IP Address>
UNIX/Linux/Mac syntax
arp -s <IP Address> <Serial Number> temp
ping -s 408 <IP Address>
4. Check that the network cable is connected to the AXIS P1311 and then start/restart the AXIS
P1311, by disconnecting and reconnecting power. If PoE is used, start/restart the AXIS P1311 by
disconnecting and then reconnecting the network cable.
5. Close the command prompt when you see 'Reply from 192.168.0.125:...' or similar.
6. In your browser, type in http://<IP address> in the Location/Address field and press Enter on
your keyboard.
Notes:
• To open a command prompt in Windows: from the Start menu, select Run... and type cmd. Click OK.
• To use the ARP command on a Mac OS X, use the Terminal utility in Application > Utilities.
Notes
When enabled on your computer, the camera is automatically
detected and added to "My Network Places."
Applicable to browsers with support for Bonjour. Navigate to the
Bonjour bookmark in your browser (e.g. Safari) and click on the
link to access the camera's web pages.
A free service from Axis that allows you to quickly and simply
install your camera. Requires an Internet connection with no
HTTP proxy. See www.axiscam.net for more information.
See below. The command must be issued within 2 minutes of
connecting power to the camera.
To view the admin pages for the network DHCP server, see the
server's own documentation.
Windows example
arp -s 192.168.0.125 00-40-8c-18-10-00
ping -l 408 -t 192.168.0.125
UNIX/Linux/Mac example
arp -s 192.168.0.125 00:40:8c:18:10:00
temp
ping -s 408 192.168.0.125
Page 13