Sony STR-DA80ES Operating Instructions Manual page 21

z
If you feel the surround effect is inadequate
Do the procedure below to adjust the delay time for the
center and rear speakers.
1 Press SET UP repeatedly to select OTHER SETUP.
2 Use the digital processing control buttons ( V / v ) to
select CENTER DELAY or REAR DELAY and use the
buttons ( B / b ) to select the delay time.
Adjusting the speaker volume Z
Use the remote while seated in your listening position
to adjust the volume of each speaker.
Note
This receiver incorporates a new test tone with a frequency
centered at 800 Hz for easier speaker volume adjustment.
+
– SUB CH POSITION
0 )
— RMS —
DIRECTION
9 (
— SOUND FIELD —
ON/OFF GENRE
SOUND FIELD
EQ/
TONE BAND
ON/OFF
DIGTAL DIRECT
PROCESSING
CONTROL
DPC MODE
DPC
MODE
PROGRAMMABLE
DIGITAL
PROCESSING
CONTROL
1
Press SOUND FIELD ON/OFF to turn on the
sound field.
2
Press GENRE repeatedly to select "DOLBY."
3
Press MODE to select "NORMAL SURROUND"
or "ENHANCED SURROUND."
4
Press DPC MODE repeatedly until the SUR
indicator lights up.
5
Press TEST TONE.
You will hear the test tone from each speaker in
sequence.
ANT
SWAP TV/VTR
= + D. SKIP
GENRE
CLEAR P IN P JUMP
p P r
TEST
MODE TONE
TEST TONE
SLOPE — LEVEL —
+ +
MODE
REAR CENTER
– –
MASTER
BASS
VOL
BOOST
MUTING
Dolby Surround Setup
6
From your listening position, use the digital
processing control buttons (
parameter to be set and use the buttons (
to select the setting so that the test tone can be
heard at the same level from all speakers.
To adjust Select
rear speaker REAR L R
balance
rear speaker REAR
level
center speaker CENTER
level
subwoofer SUB WOOFER
level
During adjustment of the respective speaker level/
balance, the test tone is output from the speaker(s)
only.
After adjusting the subwoofer level, the test tone
turns off automatically.
To turn off the test tone
Press TEST TONE.
Notes
• Be sure to select "NORMAL SURROUND" or
"ENHANCED SURROUND" before outputting the test
tone.
• The test tone is not output when:
— The DIRECT PASS button is on.
— "MUTING" appears in the display.
Getting Started
/ ) to select the
/ )
And set between
L (left) and R (right)
–20.0dB and +10.0dB
(in 0.5 dB steps)
–20.0dB and +10.0dB
(in 0.5 dB steps)
–20.0dB and +10.0dB
(in 0.5 dB steps)
21