Danfoss HC6000 User Instructions page 10

1. To enter THERMOSTAT mode press both
GB
and
2 seconds to enter WEEKEND into WEEKDAY
override.
2. Press both
second time and hold down for 2 seconds
to enter THERMOSTAT mode. The default
setting is heat only.
3. Once in THERMOSTAT mode it is possible to select the
required heating and cooling temperatures and the thermostat
operating mode, see below for setting details.
4. Use
5. Press SELECT button to select COOL mode
then use
cooling temperature.
6. Press SELECT button twice again to return
to AUTO mode. The thermostat will now
operate heating and cooling to maintain the
selected temperatures.
7. Should Heat only or Cool only be required, use SELECT button
to select required service.
8. Should system OFF be required, use SELECT
button to select "Off ".
Please note: Frost protection is not provided in OFF mode.
THERMOSTAT mode can be cancelled at any time by pressing
both and
This will return the unit to normal running mode.
10
buttons together and hold down for
and buttons together for a
or buttons to select required heating temperature.
or buttons to select required
buttons together and holding down for 2 seconds.