Table of Contents
Advertisement
Copy Your Tapes (Dubbing)
*Important: If a remote control button does not work when pressed,
press the COMBO button on the remote and try the button again.
Connections you'll need to make.
Playing (Source) VCR
AUDIO
VIDEO
OUT
IN
Playback (Source)
1
Insert pre-
recorded tape.
2
3
Press PLAY then
PAUSE at starting
point to put in
Standby mode.
(Perform operation of steps 4 and 5 on both units at same time.)
4
Press PLAY
to start dubbing.
5
Press STOP
to stop dubbing.
STOP
Caution
• Unauthorized exchanging
and/or copying of copyrighted
recordings may be copyright
infringement.
IN FROM ANT.
OUT TO TV
Recording (Editing) unit
Select "LINE" mode.
See "Selecting Input Mode" below.
Selecting Input Mode
Method 1:
Press CH
. The display will change as follows.
Method 2:
a Press ACTION for MAIN MENU.
b Press
ACTION for SET UP TV screen.
c Press
to select "INPUT SELECT," and
then press
to select "TUNER" or "LINE."
d Press ACTION twice to exit this mode.
Recording (Editing) unit
VIDEO IN
AUDIO IN
AUDIO IN
Insert blank tape with
record tab.
• Dubbing tapes protected
with Copy Guard will have
poor quality results.
Press REC, then
PAUSE/SLOW
immediately to put in
Standby mode.
Press PAUSE/SLOW
to start dubbing.
Press STOP
to stop dubbing.
1
2
3
(CABLE)
(TV)
LINE
125
or
69
to select "TV", then press
13
Advertisement
Table of Contents
