Timer Recording - Panasonic PV-C2522-K Operating Instructions Manual

*Important: If a remote control button does not work when pressed,
press the COMBO button on the remote and try the button again.
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording.
• Any future daily or weekly recordings
will be performed as programmed.
SELECT/SET
:CH UP
:CH DOWN
:VOL UP
:VOL DOWN
PROG
ADD/DLT
STOP
Review, Replace or Clear Program
Contents :
(Recording is not in progress)
1
Repeat steps 1 and 2 on page 20.
2
P DT START STOP CH SPD
1 1 day day 9 9 : : 00 00p p 12 12 : : 00 00a a 08 08 SP SP
2 8 10 : 00a 12 : 00p 125 SP
3 10 8 : 00p 9 : 00p 10 SP
4 SU 9 : 00p 10 : 00p L LP
CANCEL : ADD / DLT
SELECT 1 - 8 :
ENTER :
END : PROG / ACT I ON
3
To Replace program...
DATE START STOP
8 8 SAT SAT 9 9 : : 00 00P P 12 12: : 00 00A A 08 08
ABC
TODAY
CATEGORY : MOV I E
----------------------------------------------
SEL L E E C C T T START SE START D D AT ATE E
SELECT :
SET :
END : PROG / ACT I ON
To Clear program...
P DT START STOP CH SPD
1 1 -- -- -- -- : : -- -- -- -- : : -- -- -- --
2 8 10 : 00p 12 : 00a 125
3 10 8 : 00p 9 : 00p 10
4 SU 9 : 00p 10 : 00p L
SELECT 1 - 8 :
ENTER :
END : PROG / ACT I ON
4
Press PROG twice (or ACTION)
to exit this mode.
Notes
• 2 minutes before Timer recording is performed,
"PLEASE PREPARE FOR TIMER REC" appears and/
or the PROG TIMER Indicator flashes. Be sure a
cassette with record tab is loaded and the unit is in
Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up during
a normal recording or One Touch Recording (page 12),
the Timer Recording will not be performed.
• If there is a power interruption of more than one minute,
the recording may not be performed or continued.
• If "INCOMPLETE" appears after all items have been
set, check all entries and make necessary corrections.
Press
to select
the desired program.
1) Press
to display.
CH
2) Press to select
and press
or
SP
to set new program
contents.
3) Press PROG (or
ACTION).
Press ADD/DLT.
-- --
SP
SP
LP
21