The Atlantis Land logo is a registered trademark of Atlants Land SpA. All other names mentioned mat be trademarks or registered trademarks of their respective owners. Subject to change without notice. No liability for technical errors and/or omissions. FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
ABLE OF ONTENTS ABOUT THIS GUIDE ... 1 ERMS VERVIEW OF THIS INTRODUCTION IGABIT THERNET THERNET WITCHING ECHNOLOGY ... 5 EATURES Ports ... 5 Performance features UNPACKING AND SETUP ... 6 NPACKING ... 6 ETUP ESKTOP OR HELF NSTALLATION ONNECTING ETWORK ...
For simplicity, this documentation uses the terms “Switch” (first letter upper case) to refer to the 10-port 10/100/1000Mbps Gigabit Ethernet Switch, and “switch” (first letter lower case) to refer to all Ethernet switches, including the 10-port 10/100/1000Mbps Gigabit Ethernet Switch.
NTRODUCTION This section describes the features of the 10-port 10/100/1000Mbps Gigabit Ethernet Switch, as well as giving some background information about Gigabit Ethernet, Fast Ethernet and Switching technology. Gigabit Ethernet Technology Gigabit Ethernet is an extension of IEEE 802.3 Ethernet utilizing the...
to perform 10 times the number of operations in the same amount of time. In addition, the phenomenal bandwidth delivered by Gigabit Ethernet is the most cost-effective method to take advantage of today and tomorrow’s rapidly improving switching and routing internetworking technologies.
Ethernet or fast Ethernet LAN segments. Switching is a cost-effective way of increasing the total network capacity available to users on a local area network. A switch increases capacity and decreases network loading by making it possible for a local area network to be divided into different segments which don’t...
Features The 10-port 10/100/1000Mbps Gigabit Ethernet Switch was designed for easy installation and high performance in an environment where traffic on the network and the number of users increase continuously. Switch features include: Ports ♦ Two 10/100/1000Mbps Gigabit Ethernet port (port 9 ~ 10).
If any item is found missing or damaged, please contact your local reseller for replacement. Setup The setup of the Switch can be performed using the following steps: ♦ The surface must support at least 5 kg. ♦ The power outlet should be within 1.82 meters (6 feet) of the device.
Switch. Desktop or Shelf Installation When installing the Switch on a desktop or shelf, the rubber feet included with the device must be first attached. Attach these cushioning feet on the bottom at each corner of the device. Allow enough ventilation space between the device and the objects around it.
EIA standard size, 19-inch rack, which can be placed in a wiring closet with other equipment. To install, attach the mounting brackets on the switch’s front panel (one on each side) and secure them with the screws provided.
Power on The 10-port 10/100/1000Mbps Gigabit Ethernet Switch can be used with AC power sources 100 - 240 VAC, 50 - 60 Hz. The Switch’s power supply will adjust to the local power source automatically and may be turned on without having any or all LAN segment cables...
This chapter describes the front panel, rear panel and LED indicators of the Switch Front Panel The front panel of the Switch consists of 8 10/100Mbps Ethernet ports, 2 10/100/1000Mbps Gigabit Ethernet port, and LED indicators. Figure 3-1. Front panel view of the 10-port 10/100Mbps Gigabit ♦...
Rear Panel The rear panel of the Switch consists of an AC power connector. The following shows the rear panel of the Switch. Figure 3-2. Rear panel view of the 10-port 10/100/1000Mbps Gigabit ♦ AC Power Connector This is a three-pronged connector that supports the power cord.
Page 16
Figure 3-4. The 10-port 10/100/1000Mbps Gigabit Ethernet Switch ♦ POWER After turning on the power, the Power indicator on the front panel should light to indicate the Switch is receiving power. ♦ SPEED The indicator lights amber when the port is connected...
If you continue to have problems you should contact the dealer where you bought this product. If you have any other questions you can contact the Atlantis Land company directly at the following address: AtlantisLand spa Via Gandhi 5 Ing2,Scala A...
Page 18
IEEE 802.3 10BASE-T Ethernet IEEE 802.3u 100BASE-TX Fast Ethernet Standards: IEEE 802.3z 1000BASE-T Gigabit Ethernet ANSI/IEEE 802.3 Auto-negotiation IEEE 802.3x Full duplex Flow Control Protocol: CSMA/CD Ethernet: 10Mbps (half-duplex), 20Mbps (full-duplex) Data Transfer Fast Ethernet: 100Mbps (half-duplex), 200Mbps (full-duplex) Rate: Gigabit Ethernet: 1000 Mbps (half-duplex), 2000 Mbps (full-duplex) Topology Star...