Connections; Adjusting - Omnitronic DD-5220 Operating Instructions Manual

1. Dustcover
2. Hinge
3. Puck
4. Platter
5. Center
6. Slipmat
7. Voltage selector
(underneath the platter)
8. Power switch with
strobe-lamp

6. CONNECTIONS

Always connect the turntable's RCA connection plugs with the Line-inputs of your mixer.
Typ/Type/Type: DD-5220
Spannungsversorgung/Power supply/
Alimentation: 115 V/230 V AC, 50/60 Hz
Gesamtanschlusswert/Power consumption/
Puissance de rendement: 15 W
OMNITRONIC SHOWEQUIPMENT GmbH, GERMANY
Connect the RCA-cables (white=left channel, red=right channel) with the PHONO IN-sockets of your
amplifier or mixer. Connect the ground lead with the ground terminal of your amplifier or mixer.
You can connect a footswitch etc. with the REMOTE START/STOP socket.
You can connect a beatcounter etc. with the PITCH OUTPUT-socket.
Connect the turntable to the mains.

7. ADJUSTING

A) Adjusting the counterweight
• Remove the stylus cover.
• Set the Anti-skating-wheel to the 0 position.
• Set the tonearm lift to the down position
• Release the tonearm from the armrest and move it to a position between the turntable and the armrest.
Make sure that you do not damage the stylus.
• Carefully hold the tonearm and adjust the counterweight by turning it clockwise or anti-clockwise
respectively. The tonearm should be balanced to a horizontal position.
• Move the tonearm back to the armrest and clamp it.
• Set the scale on the counterweight to the 0 position without turning the counterweight.
• Turn the counterweight clockwise until the scale shows the value corresponding to the pressure of the used
stylus. Please follow the pick-up system manufacturer's instructions.
B) Adjusting the tracking force
Set the Anti-skating-wheel to the value equivalent to the pressure of the used stylus. Please follow the pick-
up system manufacturer's instructions.
C) Adjusting the playback-speed
• Press the START/STOP-button and the turntable begins to rotate.
• You can adjust the playback-speed by up to 20 %. If you wish to adjust the playback-speed by +/- 20 %
press the +/- 10 %/20 % button. If you wish to have the exact playback-speed with 0 % adjustment, press the
QUARTZ LOCK-button.
9. START/STOP-button
10. Speed-selector
11. Target light
12. Lamp switch
13. Headshell
14. Auto pitch button
15. +/- 10 %/20 % button
16. QUARTZ LOCK-button
17. Pitchfader
18. Direction-button
CAUTION
Read manual before use. To prevent electrical fire and shock hazard,
do not expose this appliance to moisture. Risk of electric shock!
~
Do not open! There are no serviceable parts inside the device.
Vor Gebrauch Anleitung lesen. Gerät vor Feuchtigkeit schützen.
Gefahr! Gerät nicht öffnen!
sich keine zu wartenden Teile.
Lire le mode d'emploi avant l'utilisation. Afin de prévenir tous risques
d'électrocution et de court-circuits, ne pas exposer à l'humidité.
Attention! Ne pas ouvrir le boîtier!
ne contient pas de parties nécessitant un entretien.
www.omnitronic.com
Im Geräteinneren befinden
L'intérieur de l'appareil
17
19. Tonearm
20. Adjusting-ring for adjus-
ting the tonearm-height
21. Armrest
22. Tonearm-clamp
23. Tonarm-lift
24. Anti-Skating-wheel
25. Counterweight-scale
26. Counterweight
27. Cartridge holder
®
OMNITRONIC
PITCH
OUTPUT START/STOP
REMOTE