Setting Auto Adjust; Setup [Page 3 - NEC HT1100 User Manual

Setting Auto Adjust

This feature sets the Auto Adjust mode so that the RGB image can be
automatically or manually adjusted for noise and stability. You can auto-
matically make adjustment in two ways: Normal and Fine
Off .................. The RGB image will not be automatically adjusted.
You can manually optimize the RGB image.
Normal ........... Default setting. Normally select this option.
Fine ................ Select this option if fine adjustment is needed. It takes
more time to switch to the source than when "Nor-
mal" is selected.

Setup [Page 3]

Setting a Password [Password (Logo)]
A password can be set for your projector to avoid operation by an unau-
thorized person.
When a password is set, doing any one of the following two operations
will display the Password input screen.
* Changing the background
* Changing the logo data in a PC card
Entry:
To assign your password:
NOTE: Up to 15 alphanumeric characters can be assigned.
1. Type a password.
Highlight "Entry" and press the ENTER button.
The "Enter the Password" screen will be displayed.
Make sure that is highlighted and then press the ENTER button.
The Software keyboard appears. Use the Software keyboard to type
a password and then highlight "OK" on the "Enter the Password"
screen and press the ENTER button.
The [Confirm Password] screen will be displayed.
2. Type the same password again. Highlight "OK" on the "Enter the Pass-
word" screen and press the ENTER button.
Your password will be assigned.
Delete:
To delete your password:
1. Highlight [Delete] and press the ENTER button. The "Current Pass-
word" screen will be displayed.
2. Use the Software keyboard to type your password. Highlight "OK" on
the "Current Password" screen and then press the ENTER button.
Your password will be deleted.
Setting LAN Mode [LAN Mode]
This feature allows you to set various setting items when the projector is
used on your network.
Consult with your network administrator about these settings.
CAUTION: Make sure that the LAN card is removed during Power-
saving mode (NOT Idle mode) or with the main power off.
Failure to do so may cause damage to the data on your PC card.
Note to Users of a PCMCIA network card:
Use of a non-supported network card in the projector may cause the
unit to malfunction.
Should this happen, turn off the projector and remove the network
card from the projector's PC card slot.
NOTE: LAN card is not available when a PC card is used for the Viewer function.
Viewer is not available when LAN card is used for LAN connection.
IP Address:
An IP address can be automatically assigned to this projector by your
DHCP server. If your network does not automatically assign IP address,
ask your network administrator for an address, and then register it manu-
ally.
Automatic:
Automatically assigns an IP address to the projector from a DHCP
server.
Manual:
Provides a space for you to register the IP address or subnet mask
number obtained from your network administrator.
IP Address:
Set your IP address. Press
type in 12 numeric characters.
Subnet Mask:
Set your subnet mask number. Press
board and type in 12 numeric characters.
Projector Name:
Specify a unique projector name. Press
keyboard and type in. Up to 16 alphanumeric characters can be used.
E-34
to display the software keyboard and
to display the software key-
to display the software