NEC HT1100 User Manual page 35

Gateway:
Set the default gateway of the network connected to the projector.
Press to display the software keyboard and type in 12 numeric
characters. Checking this box will make the set default route valid.
When data is sent from the LAN card, the transfer location will be
searched according to the previously set routing information; how-
ever, when the transfer location has not been found as a result of the
search, the data will be sent to the device that holds the IP address
set here. The IP address that is set here must be one that can be
identified by a search of the routing information.
DNS Configuration:
Type in the IP address of DNS server on the network connected to
the projector. 12 numeric characters are used.
Domain Name:
Type in domain name of the network connected to the projector. Up
to 60 alphanumeric characters can be used.
DHCP:
Depending on your network environment, acquiring an IP address from
a DHCP server may not be possible.
Should this happen, consult your network administrator to make changes
to the following settings.
Host Name option:
Select whether or not to add option hostname for DHCP.
None ............................. Not add
Request ........................ Add at the time of DHCP_REQUEST.
Discover/Request ......... Add at the time of DHCP_DISCOVER and
DHCP_REQUEST.
Host Name:
Type in a hostname. This field is available only when "Request" or
"Discover/Request."
Client-identifier option:
Select whether or not to add option client identifier for DHCP.
None ............................. Not add
Request ........................ Add at the time of DHCP_REQUEST.
Discover/Request ......... Add at the time of DHCP_DISCOVER and
DHCP_REQUEST.
Use MAC address:
Turn on to use MAC address for Client-identifier.
Client-identifier:
Type in a client identifier.
Mail:
Alert Mail:
Checking this box enables Alert Mail feature.
This option notifies your computer of an error message via e-mail
when using wired LAN. The error message will be notified when the
projector lamp has reached the end of its usable life or an error oc-
curs in the projector.
Sample of a message sent from the projector:
The lamp is at the end of its usable life. Please replace the lamp.
Projector Name: X X X X
Lamp Hour Meter: xxxx [H]
Projector Usage: xxxxxx [H]
Sender's Address:
Specify the senders address. Use the Software keyboard. Up to 60
alphanumeric and symbols characters can be used. See "Using Soft-
ware Keyboard" in Appendix for more details.
SMTP Server Name:
Type in the SMTP server name to be connected to the projector. Up
to 60 alphanumeric characters can be used.
Recipient's Address 1 to 3:
Type in your recipient's address. Up to 60 alphanumeric and symbols
characters can be used.
Test Mail:
Send a test mail to check if your settings are correct.
NOTE: If you entered an incorrect address in a test, you may not receive an Alert
mail. Should this happen, check if the Recipient's Address is correctly set.
NOTE: Unless any one of the "Sender's Address", "SMTP Server's Name" or
"Recipient's Address 1-3" is selected, "Test Mail" is not available.
NOTE: Be sure to highlight "OK" and press the ENTER button before executing
"Test Mail".
E-35