For Macintosh Users - Brother MFC-J6925DW Quick Setup Manual

For Wireless Network Users
Manual setup from the
20
control panel using the
Setup Wizard
Macintosh and mobile devices)
You must have the wireless settings you
wrote down for your network in step 19-b on
page 32 before you proceed.
a
Press .
Press Setup Wizard.
When Switch Network interface to
wireless? is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
b
The machine will search for available SSIDs. It
will take several seconds to display a list of
available SSIDs.
If a list of SSIDs is displayed, swipe up or down,
or press a or b to choose the SSID you wrote
down in step 19-b on page 32.
Press OK.
If the wireless access point/router of the
selected SSID supports WPS and the machine
asks to use WPS, go to c.
If the machine asks you to enter a Network
Key, go to d.
Otherwise, go to e.
NOTE
• If the list is blank, check that the wireless
access point/router has power and is
broadcasting the SSID. Move your machine
closer to the wireless access point/router and
try starting from a again.
• If your access point is set to not broadcast the
SSID, you will have to manually add the SSID
name. For more information, see Configure
Your Wireless Network When the SSID Is Not
Broadcast in the Software and Network User's
Guide.
c
Press Yes to connect your machine using
WPS. (If you choose No (Manual) to
continue manual configuration, go to d to enter
a Network Key.)
When the Touchscreen instructs you to start
WPS, press the WPS button on your wireless
access point/router, and then press Next to
proceed.
Go to e.
d
Enter the Network Key you wrote down in
step 19-b on page 32 using the Touchscreen.
34
NOTE
®
(Windows ,
e
NOTE
For mobile device users:
• Connect your mobile device to a wireless access
• Download and install Brother iPrint&Scan
• To download the User's Guide for the application
http://solutions.brother.com/
To install MFL-Pro Suite, continue to
step 21.
For Windows
Page 38

For Macintosh users:

Page 41
Press to cycle between lower case and
upper case. Press
letters, numbers and special characters. (The
characters available may differ depending on
your country.) To move the cursor to the left or
right, press d or c.
(For more information, see Entering Text
on page 44.)
Press OK when you have entered all the
characters, then press Yes to apply your
settings.
Your machine will now try to connect to your
wireless network. It may take a few minutes.
Press OK.
If the connection failed, check the error code on
the printed report and refer to Troubleshooting
on page 36.
Wireless setup is now complete.
The Wi-Fi LED
lights up, indicating that the machine's
Network I/F is set to WLAN.
point/router using a Wi-Fi connection.
(Android™/iOS/Windows
mobile device's application download site. You can
also use AirPrint (iOS) with this machine.
you are using (Brother iPrint&Scan/AirPrint), visit
the Brother Solutions Center and click Manuals on
your model's page.
Now go to
®
users:
Now go to
Now go to
to cycle between
on the control panel
®
Phone) from your