Safety Instructions - Teac PVR-80S Owner's Manual

Table of Contents

WARNING

Failing to heed the instructions provided on this page could result in serious damage

to your health or damage equipment or other such property.

• Always follow these instructions to avoid the risk of injury to yourself or damage to your

equipment.

• Unplug the power cord from the AC power outlet before cleaning. Use only a damp

cloth for cleaning the exterior of the receiver.

• Do not use accessories or attachments not recommended by the manufacturer, as they may

damage the equipment and said damage is not covered by the warranty.

• Do not operate the receiver in high-humidity areas, or expose it to water or moisture.

• Do not place the receiver on an unstable cart, stand, tripod, bracket, or table.

The receiver may fall, causing serious personal injury and damage to the receiver.

• Do not block or cover slots and openings in the receiver. These are provided for ventilation

and protection from overheating. Never place the receiver near or over a radiator or heat

ventilation.

• Do not stack the receiver on top of or below other electronic devices. They should be at least

10 cm apart.

• Operate the receiver using only the type of power source indicated on the marking label.

Unplug the receiver power cord by gripping the plug, not the cord.

• Route power supply cords so that they will not be pinched by items placed on or against

them. Connect the power cord in the power outlets securely. Unplug the cord by grasping the

plug, not the cord.

• Use an outlet that contains surge suppression or ground fault protection. For added protection

during a lightning storm, or when the receiver is left unattended and unused for long periods

of time, unplug it from the wall outlet and disconnect the lines between the receiver and the

antenna.

• Do not attempt to service the receiver yourself, as opening or removing covers may expose

you to dangerous voltage, and will void the warranty. Refer all servicing to authorized

service personnel.

• The main socket-outlet for connecting mains plug shall be accessibly close to this apparatus.

• Unplug the receiver from the wall outlet carefully and refer servicing to authorized service

personnel whenever the following occurs:

The power cord is damaged;

Liquid has been spilled, or objects have fallen into the receiver;

The receiver has been exposed to rain or water;

The receiver has been dropped or the chassis has been damaged;

The receiver exhibits a distinct change in performance.

SAFETY INSTRUCTIONS

Table of Contents