Fleetwood 1997 Discovery Owner's Manual page 96

PlUMbiNq SYSTEMS
To disconnect the city water:
1. Turn OFF the city water supply.
2. Remove the hose from the city water supply valve.
3. Drain and store the hose on shelf provided.
The on-board fresh water tank can be filled in two ways: (1)
city water pressure or (2) gravity.
1. City water pressure - When connected to the city water
supply as described above, turn the bypass
valve
located in
the utility compartment to "Water Tank Fill" from the "Normal"
setting. This will fill the on-board fresh water tank.
Make sure the external
gravity
fill connection is open
(remove
the cap) to allow air to escape from the on-board tank. When
water flows out of this external fill, the on-board tank is full.
After filling, turn the bypass
valve
to "Normal:'
2. Gravity fill-The external gravity water fill is located inside the
city water/cable compartment on the exterior of the motor
home. The on-board water tank can be filled here. To fill the
fresh water tank,
remove
the cap and fill the tank using a
potable water hose.
Check the monitor panel often to determine if the tank is full.
If water is flowing from the top
vent,
your tank is overfilled.
Stop filling.
Avoid leaving the water in the tank when the motor home is
not in use. To drain the fresh water tank, open the cold low
point drain valve located in the basement utility compartment.
FilliNG THE
ON .. BoARd
WATER TANk
CAUTION
Overfilling the fresh water
tank from a pressurized
source will cause serious
damage to the water tank
or structural components.
Monitor water tank filling
continually.
- - . _ -
..
- . - . - _ . _ - - - - - - _ .
__
.
__
..
- - - - - - - _
...
- - - - _ . _ - -
DiSCOVERY - CopYRiqHT 1996, FlEETWood ENTERPRisES, INC.
All RiqHTS RESERVEd.