Fleetwood 1997 Discovery Owner's Manual page 61

Illumination of this light, accompanied by eight seconds of
short beeps from the shift selector, indicates that shifts are
being restricted. The SELECT digit on the display will be
blank. Operation may continue in order to reach service
assistance. The ECD may not respond to shift selector re-
quests since operating limitations are being places on the
transmission; i.e., upshifts and downshifts may be restricted.
Direction changes will not occur. If the shift lever is moved
while DO NOT SHIFT is indicated, a continuous alarm will
be sounded. The alarm will stop when the lever is moved back
to the previous position where DO NOT SHIFT was first
indicated. For push-button shift selectors, the ECD will not
respond to operator requests. The ECD will cause the trans-
mission to shift to a safe gear and Hold-In-Range and disen-
gage the lockup clutch.
When the do no shift light comes on, a reset procedure can
be performed to clear the system. If necessary, continue to
operate the vehicle and have the transmission checked at
the earliest opportunity.
TO RESTORE OPERATION
Lever Selector
• Bring vehicle to a stop at a safe location
• Apply parking brakes, select Neutral
• Push TEST button one time
• Select Reverse, select Neutral, return to operation*
Push-Button Selector
• Bting vehicle to a stop at a safe location
• Apply parking brake, select Neutral
DisCOVERY - CopYRiqHT 1996, FIEmvood ENTERPRisES, INC. All RiqHTs RESERVEd.
RESETTiNG THE
SHifrER TO RESTORE
OPERATioN