Sennheiser EM 100 G3 Manual page 24

If a problem occurs ...
Problem
Audio signal is distorted
No access to a certain
channel
None of the diversity
displays I or II appears
on the display panel
During the soundcheck,
only one diversity display
(I or II) appears on the dis-
play panel
If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed solutions,
please contact your local Sennheiser partner for assistance. To find a Sennheiser partner in your country, search at
www.sennheiser.com under "Service & Support".
For accessories, visit the ew G3 product page at www.sennheiser.com.
22
Possible cause
Transmitter sensitivity is adjusted too
high
Receiver's audio output level is adjusted
too high
During scanning, an RF signal has been
detected on this channel and the chan-
nel has been locked
During scanning, a transmitter of your
system operating on this channel has
not been switched off
Receiver's squelch threshold is adjusted
too high
Transmitter's RF signal is too weak
Antennas are not correctly connected
One of the antennas is not correctly
connected or not optimally positioned
Possible solution
Adjust the transmitter sensitivity correctly.
Reduce the audio output level
("AF Out", see page 17).
Set the transmitter operating on this channel
to a different channel and redo the frequency
preset scan.
Switch the transmitter off and redo the
frequency preset scan.
Reduce the squelch threshold.
Reduce the distance between transmitter and
receiver.
Check the antenna cables or the antennas
Check the antenna cables or the antennas and
reposition the antennas.